Monday, February 20, 2012

Why wont my Audi CD changer work properly?

MY 92 Audi's CD changer will not work when the car is running. However, when the car is turned off and the stereo is on it works.



It all happened after I hooked up my amp and sub. I spliced some RCA's into the rear speaker channels. And used the Stock Bose amp in the back for a remote source.



What鈥檚 going on?Why wont my Audi CD changer work properly?Check the following, in order.

1) that the power connector (not the actuation link) is getting power when the car is in accessories %26amp; with the ignition on (but the engine not turned over yet)

2) that the actuation link (it's the same voltage signal that gets fed to any retracting antenna fitted to the car) is receiving voltage with the car in accessory/ignition on with the radio on.

3) That there isn't some broken fuse or a randomly earthing wire that's causing the problem.



Other than this I'm not really able to give much of a hand as i've never had to muck about with external stackers before.

Good luck!
  • pf changs menu
  • No comments:

    Post a Comment